When stripping down a multiplier reel for cleaning, one tricky job can be getting the bearing out of the side plate.  It's made difficult because the bearing is flush fitting and you can't get a purchase underneath to pop it out.

 

The answer is to use a drill bit.  Try different sizes until you find a snug fit, then simply rock the bearing back and forward whilst lifting.  The bearing will gently ease itself out.

Picture attached shows this technique being used on a Shimano TLD 25

Next job is to wash it out.

If the bearing needs replacing - then contact Paul Bright at Reel Value.

Reel Value
PO Box 133
Newton Abbot
TQ12 5XE

Web Site: www.reelvalue.co.uk      Email: enquiries@reelvalue.co.uk

 
(c) Paul Bright - Reel Value - 18th June 2003